The RCI Remote Control Interface provides a network interface for the MCS Mic Control Surface, used to remote control mic preamps in the 6416m Mic Input Module and AllFrame in any Pro64 digital snake or audio network.
An RCI can also serve as a single-channel network monitor station; its headphone and rear-panel XLR line-level outputs can be set to monitor any active Slot in the Pro64 network. It can also sync with the MCS so that channel selections made on the MCS can be instantly monitored.
The RCI Remote Control Interface, when combined with the MCS Mic Control Surface offers unprecedented remote control capabilities for the 6416m Mic Input Module and AllFrame.
A single RCI and MCS can be used to control up to 64 channels of mic preamp inputs, regardless of their location in the network. Alternatively, any number of RCI Remote Control Interfaces can be installed throughout a Pro64® network, providing multiple control points. The Control Group function allows control of active mic channels to be divided among up to four different simultaneous users and control points.
The RCI can also be used as a stand-alone monitor station; any Pro64 network audio resource can be selected (from the RCI or MCS) and monitored using the built-in headphone and/or line-level XLR mono outputs. MCS Mic Control Surfaces can be connected and disconnected from the RCI without affecting network behavior.
|Controller Port||EtherCon RJ45, Accepts MCS|
|Headphone Monitor||1/4-inch TRS, mono, with level control|
|Monitor Output||XLR jack, balanced line level, mono|
|XLR Output||Pin 1: Shield; Pin 2: Hot; Pin 3: Cold|
|XLR Output Level||+4dBu (Pad off), -17dBu (Pad on);
|Max. Ambient Temp.||50°C|
|A-Net||2 EtherCon RJ45 connectors|
|A-Net Cable Length||400 feet (120 meters) between devices (Cat-5e)|
Internal switching type; IEC connector
|Backup DC Power Inlet||24VDC, 2.0 amp max.
4-pin XLR (Pin 1: GND; Pin 2/3 no connect; Pin 4: 24VDC)
|Dimensions||1U: 19"w x 8"d x 1.75"h (482.6 x 203 x 44 mm)|
|Weight||7 pounds (3.17 kg)|