Simple setup. Powerful performance.
On the most basic level, the D800 and the D800-Dante do an unglamorous but important job: get power and audio to your personal mixers. Set-up is a breeze, with no IP addressing, routing, or switch managing to worry about, so you can get set up and start mixing in no time, without a lot of hassle.
Get more channels to your mixers
Used in conjunction with the SB4 System Bridge and Pro16 A-Net console cards (such as the Y1 A-Net Card for Yamaha®), the D800 and D800-Dante combine up to four 16-channel A-Net streams for sending up to 64 channels directly from your digital console to your Aviom personal mixers. Mix channels can be individually selected for each A360 Personal Mixer, allowing each musician to mix exactly the sources they need.
Grow your system
If you need more than eight personal mixers, the D800 includes an A-Net Out port on the rear panel—perfect for sending the incoming audio stream (regardless of its original source) on to additional A-Net Distributors.
Precision Engineered for Reliability
From the innovative power supply sub-system to the mechanical design to the whisper-quiet thermal management, the D800 is built to give you rock-solid performance you can count on.
Network Mix Back for wireless in-ears
If you're using A360 Personal Mixers, the D800 eliminates the need for running analog cables from A360s to the transmitter units for the in-ear monitors.
Extend the interface with iOS
The D800 manages communication between A360 Personal Mixers and supported iOS devices, allowing users to run the A360 Display™ app alongside their A360.
|A-Net to/from Personal Mixers (front panel)
||Eight locking RJ45 connectors, powered;
2-position switch (I/II) accommodates A-16II and A320 (|) and the bidirectional A360 Personal Mixer (||)
|A-Net In or
A-Net Bridge In
|Accepts Pro16 or Pro16e A-Net; One locking RJ45 connector
|A-Net Out (rear panel)
||Pro16e A-Net; One locking RJ45 connector, unpowered
|A-Net Mixes Out
One locking RJ45 connector, unpowered;
Provides up to 16 channels of Network Mix Back™ data from up to eight A360 Personal Mixers
||One RJ45 connector
||Power On (red); Sync (green)
||Used for firmware updates
||Front Panel Connections: Shielded Cat-5e (or better) cable must be used to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.
Unshielded Cat-5e cable may be used on all rear panel connections
|Output Voltage for Personal Mixers
||24VDC, 0.5 amp
Transmitted over the Cat-5e cable
||Internal, universal switching type, IEC connector
||100-240VAC, 50-60Hz, 300W
Fuse - 250VAC~ T4AL
||19" (482.6 mm) wide x 14.25" (362 mm) deep;
2U, 3.5" (88.9 mm) high
||12.0 lbs (5.44 kg)