The AN-16/o v.4 Output Module connects to any Pro16 input module, console card, or A-Net distributor and provides 16 balanced TRS line-level analog outputs. Five output levels, from mic to +24dBu, are available to easily accommodate the level requirements of the gear its output signals are being connected to.
Use the AN-16/o v.4 anywhere analog outputs are required: on stage or at FOH in a digital snake, in the studio, for a recording split, or in even the most complex audio networks. Adding a digital split to a Pro16 system is as simple as connecting an additional AN-16/o v.4 Output Module.
The AN-16/o v.4 Output Module is a 1U rack-mount 16-channel digital-to-analog converter for Pro16® digital snake and audio distribution systems. Digital audio transmitted to the AN-16/o v.4 via Aviom's A-Net® Pro16 digital audio transmission protocol is converted to analog using 24-bit, 48kHz converters.
Sixteen balanced outputs are provided on the rear panel via DB25 multipin connectors. The analog outputs can be set (per channel pair) to +24dBu, +18dBu, +4dBu, or mic level.
Use the AN-16/o v.4 anywhere analog outputs are required: on stage or FOH in a digital snake, in the studio, for a recording split, or in even the most complex audio networks. Adding a digital split to a Pro16 system is as simple as connecting an additional AN-16/o v.4 Output Module.
|Audio Outputs||16 channels, balanced|
|Outputs||DB25 multipin connectors (2); Tascam® analog audio pinout
Impedance balanced output for mic, +4dBu, and +18dBu; differential output for +24dBu
|D/A Conversion||48kHz sample rate, 24 bit|
|A-Net Input/Output||one EtherCon Category 5 (RJ45 connector)|
|A-Net Expansion||one EtherCon Category 5 (RJ45 connector)|
|Output Level Settings||Four-position switch, per channel pair; +24dBu, +18dBu, +4dBu, and Mic|
|Channel LED Indicators||Signal Present and Clip, per channel|
|Metering||LEDs; green: Signal Present; red: Clip; per channel|
|Maximum Output Level||+24dBu|
|Output Impedance||226 ohms (+18dBu, +24dBu); 100 ohms (+4dBu and mic)|
|Freq. Response||4Hz-22kHz +0.2dB/-3dB|
|THD +N||< 0.004%|
|Bit Error Rate (BER)||10(-12)|
|Signal to Noise (unweighted)||92dB typical, A/D to D/A
Measured from AN-16/i to AN-16/o v.4 Output Module
|Digital Connections||A-Net In: 1; A-Net Out: 1; A-Net Expansion: 1;
Neutrik EtherCon connectors
|A-Net Pro16||A-Net Expansion combines two A-Net streams (32 channels of audio) onto one Cat-5e cable; uses unshielded Cat-5e UTP (or better) cable|
|Latency||<0.620 msec (measured from analog input to analog output)|
|External, DC, universal switching type
100-240 volts, 50/60Hz, 30VA
24 VDC, 0.5 amp
|Power||24 VDC, 500mA|
|Dimensions||19" (482.6 mm) wide x 5.75" (146 mm) deep;
|Weight||6.8 lbs. (3.08 kg)|
|Options||AN-16SBR System Bridge; used to combine up to four A-Net streams for transmission over one Cat-5e cable|