The POA80 provides power over A-Net (PoA) for the F6 Modular I/O Frame, the host device that is the basic building block of the AllFrame Multi-Modular I/O System.
The POA80 is the only power supply device approved for supplying power over the Cat-5/Cat-6 cable for AllFrame.
The POA80 Power Over A-Net Power Supply accepts one Cat-5/Cat-6 A-Net network connection and outputs the A-Net signal plus power for the F6 Modular I/O Frame. This allows the power supply to be placed up to 400 feet (120m) from the AllFrame device for ultimate system flexibility.
The POA80 requires a standard IEC power connection and may be mounted on a standard rack tray, or attached to a wall or other flat surface.
The POA80 may be used to power an F6 even when the F6 fiber ports are used for data transmission.
The F6 Modular I/O Frame can also be powered simultaneously via its 4-pin XLR and/or Euroblock terminal block power inlets, allowing redundant power supplies to be connected.
|LED Indicators||Connect - green - DC Power 'OK'
Fault - red - Fault detected
On - green - Power on/off
|Mounting||Four mounting holes on the tray allow the unit to be attached to a rack shelf or other flat surface.|
|A-Net Connections||One Pro64 network A-Net In
One Pro64 network A-Net plus DC power Out
Connects to A-Net Port B only on F6
EtherCon RJ45 connectors
|AC Input Voltage Range||100 to 240VAC, 47-63Hz|
|AC Power Inlet||Removable IEC electrical connector|
|Total Output Power||80W|
|DC Output Voltage||+56V|
|Operating Temperature||-40 to +55°C|
|Dimensions (POA80)||13.25 x 7.0 x3.04 in. (336.55. x 177.8 x 77.21 mm)|
|Shipping Dimensions||16 x 10.5 x 7 in. (406 x 266.7x 177.8 mm)|
|Weight||9 pounds (4.08 kg)|