Auckland  09 414 0477
Wellington  04 801 9494

Aviom AV-P2

Aviom AV-P2
larger imageMove mouse over the image to magnify
NZ $1,204.00

Product Highlights

  • Provides 1- or 2-channel analog output from a Pro16® A-Net® stream
  • Independently selectable output levels for left and right channels
  • 48kHz, 24-bit D/A converters
  • Optional power over Cat-5e using a Pro16 A-Net Distributor
  • Reversible mounting flanges

The AV-P2 Output Module is designed to provide a 1- or 2-channel analog output from a 16-channel Pro16® A-Net® stream, easily selected using a front-panel rotary switch. Independent output levels for the left and right channels are set using DIP switches.

Power can be supplied to the AV-P2 with an external DC power supply or over the Cat-5e cable when connected to an A-Net Distributor.

Each AV-P2 Output Module in a Pro16system receives a 16-channel A-Net stream from an input module, console interface card, A-Net distributor, or Pro64® audio network (via the ASI A-Net Systems Interface module). It provides a one or two channel, mono or stereo analog output from that 16-channel digital audio stream.


Channel Selection

A front-panel rotary switch allows the output to be set to any one of those 16 source channels. If the selected channel is part of a stereo pair (set at the input module), the left and right channels are automatically routed to the left and right outputs on the AV-P2. If the selected channel is not part of a stereo pair, the selected mono channel's audio is routed to both the left and right outputs. The analog output level for each channel is set with front-panel DIP switches.


System Flexibility

AV-P2 modules can be connected in any combination of serial or parallel connections, using Pro16 A-Net Distributors. There is no limit to the number of devices that can be daisy chained, or to the number of parallel splits in a single system. The AV-P2 is compatible with all Pro16 Series products and can be used in any combination with A-16II and A-16R Personal Mixers, the AN-16/o Output Module, and the A-16D and A-16D Pro Distributors.

Audio is distributed to the AV-P2 over standard Cat-5e cables, using Aviom's A-Net digital audio protocol which supports plug-and-play installation, real-time distribution with sub-millisecond latency, and long cable runs up to 500ft/150m. Power can be supplied to the AV-P2 with an external DC power supply or over the Cat-5e cable (with an A-Net Distributor).


Mounting Options

The AV-P2 includes reversible mounting flanges. Two AV-P2 modules can be mounted side by side on a standard 1U rack tray.

Audio Outputs 2, impedance balanced line-level
5.0 mm Euroblock connectors, female, panel- mount
2 male Euroblock connectors supplied in box
Screw terminals: Audio +; Audio -; Ground
Channel Selection 16-position rotary switch
D/A Conversion 48kHz, 24-bit
Output Levels Maximum Output Level: +18dBu
Output Level Trim from 0dB to -35.9dB in 1.5dB steps;
6-position DIP switch, per channel
Indicators LEDs; red: Power, green: A-Net Active, yellow: Stereo Pair
Output Impedance 100 ohms
Signal to Noise
93dB typical, A/D to D/A
Measured from AN-16/i Input Module to AV-P2
Freq. Response 4Hz-22kHz +0.2dB/-3dB
THD +N -93dB at -10dBFS
Crosstalk -85dB at 1kHz
Bit Error Rate (BER) 10-12
Digital Connections A-Net In: 1; A-Net Out: 1; RJ45 connectors
Pro16 A-Net® Uses unshielded Cat-5e UTP (or better) cable
Latency <0.880 msec (measured from analog input to analog output)
Power Supply
   Input Voltage
   Output Voltage
   Plug Size
External, DC, universal switching type
100-240 volts, 50/60Hz, 30VA
18-24 VDC, 0.5 amp
2 mm, locking, center pin hot
Dimensions 7.45" (189.2 mm) wide x 7" (177.8 mm) deep; 1U high
Weight 3.4 lbs (1.54 kg)

Signup For Our Newsletter

Subscribe for the latest product news, special offers and invitations.

Give Us Your Feedback

We would love to hear what you think of our website and your experiences with our company. Drop us a line here.

Contact Us 

Auckland: 09 414 0477
Wellington: 04 801 9494

Australia: 1300 472 344