With its new higher power outputs (+24dBm) at lower noise (-100dBm EIN) the updated DA1000 is ideal for every application and every budget.
Avoid RF and hum pick-up problems from noisy, lossy splitters. Prevent hard-to-find shorts from multiple taps on critical lines. Boost low console outputs. Drive long lines. Eliminate rolloffs and distortion from mismatched load impedances. This ATI DA is designed for permanent rack mounting and use reliable barrier block connectors with fanout strips for easy prewiring and quick change servicing.
The DA1000 has a single, high output; active balanced driver per channel, that is resistively split into 4 or 8 outputs each, all driven at precisely the same level.
This device features output clipping LEDs and a headphone/metering jack in a half rack package that you can mount singly or side-by-side in only 1-3/4".
+24dBm into 600 ohms
0.2% typical 20Hz to 20kHz
+/-.25dB, at 20 to 20,000 Hz, -3dB at 100 KHz.
-100dBm EIN, 20Hz-20KHz
70dB minimum @ 1KHz
26dB. Front panel level control.
30Kohm balanced bridging
80dB hum CMR 60-120Hz
19"W x 1-3/4"H x 7-1/2"D, 18lbs. max.
Rear Barrier Block, Fanning Strip Supplied.
21075-501 Mounts two units side by side.
115/230 VAC+/-10% 47-63 Hz.
8 1/2"Wx1 3/4"Hx7" D, 4 lbs.
Limited, One Year Warranty