Auckland  09 414 0477
Wellington  04 801 9494
03829

Aviom D800-DANTE A-Net Distributor

Aviom D800-DANTE A-Net Distributor
larger imageMove mouse over the image to magnify
The D800-Dante A-Net Distributor provides the link between the input module or console card and the personal mixers, providing power and a copy of the digital audio stream to your Aviom personal mixers, utlitizing standard Cat-5e cables. The unit also integrates additional advanced options for delivering high-channel-count audio streams to your personal mixers, streamlining connections between A360s and transmitters for wireless in-ear monitors, and integrating the A360 Display iOS app.
WAS NZ $6,608.00 NZ $6,136.00 Save NZ $472.00 Excl GST
Qty.

Simple setup. Powerful performance.

On the most basic level, the D800-Dante does an unglamorous but important job: get power and audio to your personal mixers. Set-up is a breeze, with no IP addressing, routing, or switch managing to worry about, so you can get set up and start mixing in no time, without a lot of hassle.
 

Get more channels to your mixers

Used in conjunction with the SB4 System Bridge and Pro16 A-Net console cards (such as the Y1 A-Net Card for Yamaha®), the D800-Dante combines up to four 16-channel A-Net streams for sending up to 64 channels directly from your digital console to your Aviom personal mixers. Mix channels can be individually selected for each A360 Personal Mixer, allowing each musician to mix exactly the sources they need.
 

Connect directly to Dante

If your audio system includes a Dante™ audio network, the D800-Dante can interface directly to the network. Assign up to 64 channels from Dante to the D800-Dante for distribution to the Aviom personal mixers. Rear-panel DIP switches are used to set the stereo links for channels going to the personal mixers.
 

Dante Sample Rates Up to 192kHz

With the D800-Dante, you can run your Dante network a 44.1/48kHz, 88.2/96kHz, or 176.4/192kHz. At higher sample rates, the D800-Dante converts the audio data to 48kHz for distribution to the Aviom Personal Mixers (and other A-Net devices).
 

Grow your system

If you need more than eight personal mixers, the D800-Dante includes an A-Net Out port on the rear panel—perfect for sending the incoming audio stream (regardless of its original source) on to additional A-Net Distributors.
 

Precision Engineered for Reliability

From the innovative power supply sub-system to the mechanical design to the whisper-quiet thermal management, the D800-Dante is built to give you rock-solid performance you can count on.


Network Mix Back for wireless in-ears

If you're using A360 Personal Mixers, the D800-Dante eliminates the need for running analog cables from A360s to the transmitter units for the in-ear monitors.
 

Extend the interface with iOS

The D800-Dante manages communication between A360 Personal Mixers and supported iOS devices, allowing users to run the A360 Display™ app alongside their A360.
Dante Primary I/O Locking RJ45 connector
Dante Secondary I/O Locking RJ45 connector
Stereo Link Four DIP Switch blocks: 1-16, 17-32, 33-48, and 49-64; used to set up to 32 channel pairs as stereo links
Stereo Link Defeat Bypasses DIP switch stereo link settings
Disable DIP switch Chooses Dante (down) or A-Net In (up) as the input source for the D800-Dante
ID1, ID2 DIP Switch Reserved
A, B, C, D DIP switch Reserved
LEDs (rear panel) Error (red);
Sync (green);
1GB Active (red);
Network Activity (green)
Supported Dante Sample Rates 44.1, 48, 88.2, 96, 176.4, 192kHz
A-Net to/from Personal Mixers (front panel) Eight locking RJ45 connectors, powered;
2-position switch (I/II) accommodates A-16II and A320 (|) and the bidirectional A360 Personal Mixer (||)
A-Net In or
A-Net Bridge In
Accepts Pro16 or Pro16e A-Net; One locking RJ45 connector
A-Net Out (rear panel) Pro16e A-Net; One locking RJ45 connector, unpowered
A-Net Mixes Out Pro16e A-Net;
One locking RJ45 connector, unpowered;
Provides up to 16 channels of Network Mix Back™ data from up to eight A360 Personal Mixers
Ethernet One RJ45 connector
LEDs Power On (red); Sync (green)
USB Used for firmware updates
A-Net Cables Front Panel Connections: Shielded Cat-5e (or better) cable must be used to stay below the CISPR 22 Class B, ICES-003, and FCC 47 CFR Part 15 Class B emissions limits.
Unshielded Cat-5e cable may be used on all rear panel connections
Output Voltage for Personal Mixers 24VDC, 0.5 amp
Transmitted over the Cat-5e cable
Power Supply Internal, universal switching type, IEC connector
Input Voltage 100-240VAC, 50-60Hz, 300W
Fuse - 250VAC~ T4AL
Dimensions 19" (482.6 mm) wide x 14.25" (362 mm) deep;
2U, 3.5" (88.9 mm) high
Weight 12.0 lbs (5.44 kg)
0

Signup For Our Newsletter

Subscribe for the latest product news, special offers and invitations.

Give Us Your Feedback

We would love to hear what you think of our website and your experiences with our company. Drop us a line here.

Contact Us 

Auckland: 09 414 0477
Wellington: 04 801 9494

Australia: 1300 472 344

fbtw